ECU Master EMU Black Cage Mount Guide

What’s included


  • ECU Mount Deck
  • ECU Lid Mount
  • Pair of Half Moon Bar Clamps
  • Set of 4 pre-selected Roll Bar Clamp Inserts
  • Mounting installation hardware
    • 1 M6 screw (ECU to Cage Mount)
    • 4 M4 screws (Lid to Deck mount)
    • 4 M5 Socket Head Screws (Mount to Roll Bar)

Installation instructions

*CAUTION* DO NOT overtighten fasteners. It is advised to turn fasteners until they contact the part plus additional 1/8-1/4 turn depending on feel.

  1. Assemble The ECU Lid Mount and ECU Mount Deck together using M4 screws.
  2. Insert M5 Socket Head Screws into the Half Moon Bar Clamps. They might be a little tight to go in, however this allows the screws to stay in place during assembly to the cage.
  3. Install Roll Bar Clamp Inserts into Half Moon Bar Clamps and ECU Mount Deck.
  4. Install ECU Mount to the Cage of your car with Half Moon Bar Clamps and loosely tighten screws.
  5. Connect all ECU connectors and hoses.
     
  6. Slide ECU into the ECU Mount and fasten with M6 Screw. *NOTE* ECU to Mount tolerances are tight, so ECU will fit snug into the Mount and requires a little force to slide in. This reduces chance of ECU falling out during installation.
     
  7. Position ECU Mount to the desired location on the cage and tighten Half Moon Bar Clamps. Enjoy your new ECU Masters EMU Black Cage Mount!